E250-DOUBLEAXE

Double reel shaft for E250 semi-electric work positioner stacker

E250-DOUBLEAXE

Double reel shaft for E250 semi-electric work positioner stacker

Double reel shaft for E250 stacker. Handling accessory for a semi-electric work positioner stacker, designed for B2B workstations and specific loads.

more information

	Designation
	E250-DOUBLEAXE Double reel shaft for E250 semi-electric work positioner stacker Weight : 7.4 kg

DESCRIPTION

TECHNICAL CHARACTERISTICS

E250-DOUBLEAXE, twin reel mandrel for the E250 semi-electric work positioner

The E250-DOUBLEAXE twin mandrel adapts the E250 semi-electric work positioner for workstations that require two parallel supports for reels or rolls. It provides a dedicated configuration while retaining the powered lifting and mobility of the work positioner.

This accessory is suitable for manufacturing workshops, packing areas and workstations using several reel-based consumables. It brings the reels closer to their point of use and allows their height to be adjusted to suit the workstation layout.

Two mandrels for organised workstation supply

The two mandrels allow reels to be arranged according to the operation. This setup can assist a workstation that uses two rolls or requires two separate presentation points.

The E250 acts as the mobile support and provides lifting and lowering. The twin mandrel supplies the interface required for cylindrical loads with compatible core diameters.

Dimensions to check against the reels

Each mandrel has a diameter of 50 mm and a length of 450 mm. The technical sheet also illustrates a 250 mm spacing between the two mandrel levels.

The E250-DOUBLEAXE weighs 7.4 kg. Before use, check the internal core diameter, width and weight distribution of each reel. The total load and its centre of gravity must remain compatible with the E250 positioner.

Targeted uses in production and packaging
presenting two rolls close to a packaging station ;
organising the supply of consumables to a machine ;
preparing different reels on one work positioner ;
reducing travel between storage and the point of use ;
adjusting roll height to suit the workstation.

Prepare the setup before operation

The reels must be correctly centred on the mandrels. Their width must not create excessive overhang. When two reels are installed, the distribution of the total mass requires particular attention.

Movement should be limited to short distances on a stable floor and with adequate visibility. Check the mandrels, their mountings and reel stability before each lift.

Common questions about the E250 twin mandrel

What is the diameter of each mandrel?
Each mandrel has a diameter of 50 mm.

What length is available on the mandrels?
The stated length is 450 mm.

Can two reels of different weights be fitted?
The configuration must be assessed according to the total weight, load distribution and overall centre of gravity.

Is the twin mandrel compatible with the entire E range?
The E250-DOUBLEAXE is designed for the E250 semi-electric work positioner.

Discuss your twin-mandrel configuration with STOCKMAN

To confirm compatibility between the E250-DOUBLEAXE, your rolls, their spacing and your machine layout, contact your local STOCKMAN sales representative through our contact page.

Documentation

Data sheet

Double reel shaft for E250 semi-electric work positioner stacker

Double reel shaft for E250 semi-electric work positioner stacker

Documentation

See also...

E250